671-4079 Auto Car Engine Spark Plug Cable Ignition Wire Set of 4 for Chrysler PT Cruiser Sebring Dodge

For Chrysler PT Cruiser 2010 Classic Wagon 4-Door

For Chrysler PT Cruiser 2010 Couture Edition Wagon 4-Door

For Chrysler PT Cruiser 2009/ 2008/ 2007/ 2006/ 2004/ 2003/ 2002/ 2001 Base Wagon 4-Door

For Chrysler PT Cruiser 2009/ 2008  LX Wagon 4-Door 

For Chrysler PT Cruiser 2009/ 2008/ 2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 Touring Wagon 4-Door

For Chrysler PT Cruiser 2008/ 2005Touring Convertible 2-Door for Chrysler PT Cruiser Touring Convertible 2-Door

For Chrysler PT Cruiser 2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 Limited Wagon 4-Door

For Dodge Caravan 2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 SE for Passenger 4-Door

For Chrysler PT Cruiser 2006/ 2005 Street Cruiser Wagon 4-Door

For Chrysler Sebring 2006/ 2005/ 2004/ Base Convertible 2-Door

For Chrysler Sebring 2006/ 2005/ 2004/ Base Sedan 4-Door

For Dodge Stratus 2006/ 2005/ 2004/ 2003/ 2002/ 2001 SE Sedan 4-Door

For Dodge Stratus 2006/ 2005/ 2004/ SXT Sedan 4-Door

For Chrysler PT Cruiser 2005 Dream Cruiser Wagon 4-Door

For Chrysler PT Cruiser 2005 GT Convertible 2-Door

Replacement procedure. （Take "2005 PT Cruiser 2.4L" as an example）

Step ①: Remove the six 8mm upper manifold retaining bolts.

Step ②:Loosen the air intake clamp at the throttle body.

Step ③:Lift the upper intake manifold and retain out of the way using a bungee cord.

Step ④:Remove old plug wire.

Step ⑤:Using cotton swab, apply a very small amount of dielectric grease to the boot interior at each end (just the boot - not the terminal).Step 

⑥:Reinstall new plug wire.Step ⑦:Repeat for each cylinder until done.

Step ⑧:Lower intake manifold back in place and tighten to spec from interior bolts to the outside (no new gaskets required).

Step ⑨:Tighten clamp at air intake to throttle body.